Peiyork Emblem, The name for high quality embroidered patches and emblems    
Home > Products > Iron-On Instructions

Products: Iron-On Instructions

Instruction for applying Emblems with heat seal backing

  1. Preheat the machine to 325°F.
  2. Place the patch on the desired position, and cover it with a light-weighted cloth.
  3. Then, iron with firm pressure for 10 to 15 seconds.
  4. Preferably, heat from both topside and underside of the garment.
  5. After it is cooled down, check the adhesion.

    Note: Fabrics vary. You need to perform a preliminary test first. Emblems are only to be applied to the fabrics that can withstand temperature 325°F. Satin, nylon, or waterproof fabric might not be suitable to apply to.

 
Instruction for applying embroidery emblems with studstones
  1. Set heat-press machine to 325°F with medium to maximum pressure.
  2. Place the emblem on the desired location; if your garment is heat sensitive you may need to cover it with a lightweight, heat-resistant cloth.
  3. Use heat-press machine to iron with firm pressure for 30~35 second (adjust time if needed.)
  4. Allow cooling.

    Note: Fabrics vary. Therefore you will need to perform a preliminary test on other garment first. Emblems are only to be applied to fabrics that can withstand up to 350°F. Materials like satin, nylon, or waterproof fabric might not be suitable for heat seal backing.

 

Instruction for applying nail-head and rhinestone motifs

  1. Pre-wash garment before applying motif. Do not use fabric softener.
  2. Remove the white backing paper from the design. Design remains in place on the clear adhesive sheet.
  3. Place the clear adhesive sheet (with design) on garment. We recommend placing the white backing paper under the fabric to prevent sticking. Cover with thin white cotton cloth or Teflon.
  4. Set home iron on cotton-linen mode (no steam), and place iron directly on the white pressing cloth. Avoid any steam on the design and press firmly for 20~30 seconds in each spot until entire design has been pressed.
  5. Using heat-seal machine, set at 300~350 degrees and press for 20~30 seconds.
  6. DO NOT REMOVE CLEAR TACKY SHEET – Allow to cool.
  7. If applying to a thicker material, you may need to turn the garment inside out and press from the back accordingly. Allow to cool before removing the clear sheet.

    Note: Fabrics vary. Therefore, you need to perform a preliminary test first.

 

Home | Products | Color Charts | Testing Reports | Patch 101 | FAQ | About Peiyork | Contact Us

Copyright 2009-2018 Peiyork International Co., Inc. All rights reserved.
Your source for custom-made embroidered and sublimated patches and emblems..

Trademarks/Copyrights: All samples shown on this website are examples of work done by the factory. They are not for sale. Peiyork International assumes that all clients are authorized to use logos and trademarks submitted for reproduction.